硫酸盐还原颗粒污泥对Cr的吸附机理解析

以硫酸盐还原颗粒污泥作为研究对象,进行Cr的吸附容量研究及吸附等温线拟合,测定颗粒污泥中的硫化物含量、对比实验前后颗粒污泥的表面形态和微生物组成并采用傅里叶红外变换光谱(FTIR)分析颗粒污泥的表面基团。结果表明,颗粒污泥对Cr的吸附容量为6.84 mg/g,吸附过程可用Langmuir吸附等温式描述。颗粒污泥中硫化物含量达9.868 mg/g(湿重),对应每克颗粒污泥对Cr的最大吸附量可达10.69 mg;颗粒污泥表面生长大量的微生物,以杆菌为主,颗粒污泥表面丰富的微孔结构及微生物所分泌的胞外物均可有效吸附溶液中的Cr;FTIR分析结果显示,颗粒污泥中包含大量C=O、C-N及-S等基团,这些基团均可通过与C(rⅥ)或C(rⅢ)之间的静电吸附作用吸附溶液中的Cr。研究表明化学与生物吸附作用在硫酸盐还原颗粒污泥吸附溶液中的Cr过程中起到了重要的作用。     

污泥活性炭理化性质表征及吸附抗生素效果研究

文章以北京方庄污水处理厂的浓缩和脱水污泥为原料,采用ZnCl2活化法分别制备污泥活性炭。对制得的污泥活性炭进行表征,并将其应用于加替沙星废水的处理。研究2种污泥活性炭吸附反应的吸附时间、吸附剂投加量、pH值、初始浓度4个因子对吸附量的影响,设计正交实验。正交实验结果表明:2种污泥活性炭受到4个因子影响程度相当,表现出明显的相似性,但短期吸附时,脱水污泥表现出更好的吸附性能。初始浓度对吸附量的影响最大,获得最大吸附量的条件组合为:初始浓度200 mg/L,投加量0.05 g,pH=9,t=2 h。浓缩和脱水污泥活性炭的最大吸附量分别可达34.541 mg/g和34.925 mg/g,表明2种污泥活性炭对加替沙星均有良好的吸附效果。污泥活性炭作为一种废水吸附剂,是废水处理的一种新途径。     

Responses of protists with different feeding habits to the changes of activated sludge conditions: A study based on biomass data

Changes of protists, which were categorized into different functional groups primarily according to their feeding habits, in two full-scale municipal wastewater treatment systems experiencing sludge bulking were investigated over a period of 14 months. Protist biomass represented 3.7% to 5.2% of total biomass on average under normal sludge conditions, and the percentage increased significantly (p < 0.05) under sludge bulking conditions. The biomass of Chilodonella spp., capable of eating filamentous bacteria, tended to decrease in both systems when sludge bulking occurred, showing that the abnormal growth of filamentous bacteria did not lead to a biomass bloom of this group of protists. On the other hand, the bactivorous protists represented more than 96% of total protist biomass, and the biomass of this group, particularly the attached ciliates, increased significantly (p < 0.05) when sludge bulking occurred. The significant increase of the attached ciliates may have possibly facilitated the growth of filamentous bacteria through selectively preying on non-filamentous bacteria and further exacerbated sludge bulking. The redundancy analysis and correlation analysis results showed that the biomass changes of the attached ciliates were primarily related to the sludge volume index and to some extent related to five-day biochemical oxygen demand loading and hydraulic retention time.     

活性污泥中超氧化物歧化酶(SOD)活性测定影响因素

研究以污水生物处理中的活性污泥为对象,采用氮蓝四唑光还原法测定超氧化物歧化酶(SOD)活性,从样品制备和保存方面探讨了是否添加溶菌酶液、细胞破碎时间、酶液保存时间与保存温度等因素对SOD活性测定的影响。研究表明,溶菌酶液的加入提高了细胞破碎效果;细胞破碎的条件为99次(工作3 s,停3 s),时间为40 min时破碎效果最好;酶液保存时间在4 h内最佳;-20℃保存比4℃保存对酶活性影响小。最佳检测条件为:取样量为1 mL时,反应温度为30℃,反应时间为20 min时,SOD酶活性最大。     

好氧颗粒污泥培养及不同阶段除污性能的研究

以某味精污水处理厂厌氧池的厌氧颗粒污泥作为接种污泥,采用人工模拟配水,通过控制运行条件在序批式反应器(SBR)中成功培养出了好氧颗粒污泥。研究表明,该好氧颗粒污泥具有良好的沉降性能及除污性能。好氧颗粒污泥的形成阶段的粒径为0.1～0.5 mm,成熟后的平均粒径为2 mm。形成阶段SBR中MLSS为5 000～6 000 mg/L,对COD和NH3-N的去除率分别达到了88.1%和87.6%。成熟后SBR中MLSS为10 000 mg/L左右,对COD和NH3-N的去除率分别达到了94%和97.5%。通过电镜分析可知,好氧颗粒污泥表面主要聚集了球状菌,中部主要以丝状菌和杆状菌为主,内部为无机核心。这种明显的分层现象,充分说明了好氧颗粒污泥沿半径方向由于溶解氧的梯度分布,微生物呈层状分布,这种层状分布的结构为好氧颗粒污泥同步硝化反硝化提供了可能。     

一种新型生物絮凝剂FM-2絮凝特性及稳定性考察

文章对絮凝剂FM-1的储存稳定性以及絮凝活性分布进行了考察,发现其絮凝活性物质主要分布于上清液之中,加之储存稳定性较差的特点,为絮凝剂FM-2的制备提供了前提。絮凝剂FM-2的最佳絮凝率高达99.21%,其储存时间较长,30 d内其絮凝率可保持在90%以上;而且还具有较好的热稳定性,当加热温度从70℃升高到100℃,其絮凝率均保持在95%以上。     

污泥基活性炭的制备、表征及其应用

以城市生活污水厂脱水车间污泥为原料,采用化学活化法(ZnCl2为活化剂)在活化剂浓度为45%、活化温度为600℃、浸渍温度为45℃、活化时间为50min条件下制备污泥基活性炭。对污泥基活性炭进行了孔结构、扫描电镜(SEM)、红外光谱(FTIR)、XRD等表征分析。结果表明:该条件下制备出的污泥基活性炭碘吸附值为427.51mg/g,比表面积为329.48m2/g,大孔、中孔、微孔容积分别为0.19,0.12,0.15cm3/g。平均孔径为3.953nm。将其应用于生活污水处理,考察了污泥基活性炭投加量、pH、吸附时间对其吸附性能的影响。     

Fenton氧化对污泥脱水性能和溶解性物质作用效果的研究

研究了Fenton氧化技术在改善污泥脱水性能方面的效果,以污泥比阻和毛细吸水时间来表征污泥的脱水性能,探讨了体系的pH和反应时间对污泥脱水性能的影响以及Fenton氧化对污泥溶解性物质(SCOD+多聚糖+蛋白质)含量的影响研究表明,Fenton氧化能够明显改善污泥的脱水性能。在体系的pH=3时,反应1h后,Fenton氧化处理后污泥的CST从处理前的130.9s减少到19.7s,降幅85%;污泥SRF从处理前的3.58×108 s2/g降低到1.05×107 s2/g,降幅97%。同体系处理污泥SCOD、上清液中多聚糖和蛋白质的含量分别增加了3.7倍、2.6倍和1.5倍。     

Sewage sludge disintegration by high-pressure homogenization: A sludge disintegration model

High-pressure homogenization (HPH) technology was applied as a pretreatment to disintegrate sewage sludge. The effects of homogenization pressure, homogenization cycle number, and total solid content on sludge disintegration were investigated. The sludge disintegration degree (DDCOD), protein concentration, and polysaccharide concentration increased with the increase of homogenization pressure and homogenization cycle number, and decreased with the increase of sludge total solid (TS) content. The maximum DDCOD of 43.94% was achieved at 80 MPa with four homogenization cycles for a 9.58 g/L TS sludge sample. A HPH sludge disintegration model of DD_COD= kN^aP^b was established by multivariable linear regression to quantify the effects of homogenization parameters. The homogenization cycle exponent a and homogenization pressure exponent b were 0.4763 and 0.7324 respectively, showing that the effect of homogenization pressure (P) was more significant than that of homogenization cycle number (N). The value of the rate constant k decreased with the increase of sludge total solid content. The specific energy consumption increased with the increment of sludge disintegration efficiency. Lower specific energy consumption was required for higher total solid content sludge.     

不同SRT条件下厌氧污泥中氮元素的变化规律研究

氮素是衡量污泥性能的重要指标之一,在污泥厌氧消化过程中,污泥中所含的四种氮素形态之间可相互转化,研究其过程中的氮素变化规律对于优化厌氧消化工艺具有重要的指导意义。通过对5 d和10 d两种不同污泥停留时间(SRT)的污泥厌氧消化系统的研究,分析氮元素的变化规律。研究结果表明,SRT为5 d天和10 d的两个系统中,均无亚硝态氮的累积,实验前期,10 d的系统中硝态氮的产生速率比5 d的快,但系统运行10 d后10 d系统的硝态氮的含量低于5 d系统。在两反应系统中,氨氮的变化规律十分接近,10 d的系统中氨氮含量一直高于5 d的系统。总氮含量的变化与氨氮含量变化一致,四种形态氮素中,对总氮贡献最大的是氨氮。实验过程中,两系统中均并无明显产气现象,在SRT小于等于10 d的厌氧反应器中,虽然有发生反硝化反应,但通过该反应去除的氮素极少。